Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 4948 -- Link up Link down traps - Missing Trap Components

Cisco 4948 -- Link up Link down traps - Missing Trap Components

Hi Guys ,

While simulating traps via making a link down and again up , Cisco 4948 is sending the OID 1.3.6.1.6.3.1.1.5.3 to our monitoring device .
But it seems below variables /trap components are missing with the OID , does anyone have any hints about this ?

ifIndex
ifAdminStatus
ifOperStatus

My SNMP configuration is like

snmp-server community public RO
snmp-server community private RW
snmp-server trap link switchover
snmp-server trap-source Vlan102
snmp-server location NY
snmp-server contact XYZ
snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart
snmp-server enable traps tty
snmp-server enable traps cpu threshold
snmp-server enable traps envmon fan shutdown supply temperature status
snmp-server enable traps config
snmp-server host x.x.x.x version 2c public

Thanks & Regards

Rengith Kumar RS

1 REPLY
New Member

hi there,

hi there,

What is the IOS you're running on your 4948?

93
Views
0
Helpful
1
Replies
CreatePlease to create content