i have got cisco 6509 as the main switch & 3750 as standby switch, hsrp is running on both the switches, 2950 is the access-layer switch, both are connected to 2950, spanning tree is also enableb, now when i disconnect 6509 cable in 2950 it is taking 30 seconds of time delay, after that much of delay it is routing the packets via 3750, but when i tested between two 3750 & 1 2950, it was less than 10 seconds, any help would be appreicated
If you have a direct connectivity between 6509 and 3750 and also because both are connected to 2950 there is a loop which STP will take care and will block one port somewhere depending who is the root bridge.
Now if one port is blocked and you take out the cable between 6509 and 2950 STP should take its own time to reconverge which will take somewhere 30 sec approx so as per me behavior is correct.
Now I am not sure how come you got a different behavior when you have 2 3750 switches.
If you have all switches connected with each other and all are carrying same vlans on trunk or are on same access vlan this should be expected behavior.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.