Cisco 6509 show logging

[Anand Narayana]

i have got cisco 6509 in that i typed "show logging"i get some list of things & finally "0(emergencies) 1(alerts) 2(critical)

3(errors) 4(warnings) 5(notifications)

6(information) 7(debugging)" so how do i see these messages indivudually?

[jarathbu · Accepted solution]

Hello,

The show logging command shows the configured logging levels (0 - 7 (emergencies - debugging)).

http://www.cisco.com/en/US/partner/products/hw/switches/ps679/products_configuration_guide_chapter09186a008007f79f.html

If you need to know what specific logging messages match to which logging levels then you can check the system message guide for your appropriate version of CatOS (e.g. http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_6_3/msg__gd/smg_6_3.pdf)

Hope this helps.

Regards,

James

[Richard Burts]

The answer from James is good about logging levels and what messages are what level. But I believe that the original question really is asking how to see the individual messages.

Try the command show log buff and that should show the individual messages.

HTH

Rick

[Anand Narayana]

Hi,

Thanks for that link, it was really helpfull not only clearled my doubts also i learnt more on that.