Cisco 6509 Switch IOS Problem

[rsjavahar]

HI

i have 1 6509 with these modules

ws-x6k-sup1a-2ge 2 modules x

ws-x6248-rj-45 2 mobules

ws-x6348 3 modules

ws-x6624-fxs 1 module

the problem i have is there is no IOS/ Catos installed in the Boot flash or slot0. can any one suggest me for the sutable ios and CatOS , please its very very urgent

[glen.grant]

You don't mention how much DRAM the SUP1 card which is necessary to determine what code you can run . Some early modules only had 64 meg of dram only had 64 meg installed while later ones had 128 meg. If it only has 64 meg I would go with cat6000-supk8.7-4-3.bin . If it has 128 you can use anything you want with the caveat being you read the release notes for any rommon requirements . It want GD code use the latest 7.6 code which I think is like 7.6.17 at this point.

[rsjavahar]

sup1 DRAM is 128 flash card is 20 mb . i installed cat6000-supk8.7-4-3.bin through Xmodem. after that i am getting errors. they are

System Power On Diagnostics Complete

Boot image: mkseg1:a000e040

In Local Test Mode, Synch Failed. Retries: 4

WARNING: Pinnacle has not synchronised

Local Test Mode encounters Minor hardware problem in Module # 1

Runtime image not stored in the flash. Flash sync disabled.

Running System Diagnostics from this Supervisor (Module 1)

This may take up to 2 minutes....please wait

Pinnacle Synch Failed. Retries: 4

WARNING: Pinnacle has not synchronised

Minor hardware problem in Module # 1

Use 'show test 1' to see results of tests.

Cisco Systems Console

%SYS-1-SYS_ENABLEPS: Power supply 1 enabled

Enter password: %SYS-5-MOD_PWRON:Module 3 powered up

%SYS-5-MOD_PWRON:Module 4 powered up

%SYS-5-MOD_PWRON:Module 5 powered up

%SYS-5-MOD_PWRON:Module 6 powered up

%SYS-5-MOD_PWRON:Module 7 powered up

%SYS-5-MOD_PWRON:Module 9 powered up

%SYS-3-MOD_MINORFAIL:Minor problem in module 1

%MLS-5-FLOWMASKCHANGE:IP flowmask changed from DEST to FULL

%MLS-5-NDEDISABLED:Netflow Data Export disabled

%MLS-5-MCAST_STATUS:IP Multicast Multilayer Switching is enabled

Pinnacle Synch Failed. Retries: 4

WARNING: Switching bus not synchronised

%SYS-5-MOD_OK:Module 1 is online

%SYS-5-MOD_REMOVE:Module 4 has been removed

%SYS-5-MOD_PWRON:Module 4 powered up

%SYS-5-MOD_INSERT:Module 4 has been inserted

WARNING: Module 3 Pinnacle has not synchronised

%SYS-3-MOD_FAIL:Module 4 failed to come online

%SYS-5-MOD_REMOVE:Module 4 has been removed

after this how can i copy this file in to the bootflash/Flash . when i applied the command which boot its showing

Console> (enable) whichboot

Boot image name is 'mkseg1:a000e040'.

Console> (enable)