Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 6509 - Utilization % on Supervisor module

Hi All,

Is the Utilization % indicator on the Supervisor Module II, (ours is in a 6509), enabled by default, or is there are way to disable/enable it?

Thanks,

Darran

  • Other Network Infrastructure Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Cisco 6509 - Utilization % on Supervisor module

It's enabled by default and cannot be disabled. You would see it light up only if your backplane utilization is 20% and higher

1 REPLY
Cisco Employee

Re: Cisco 6509 - Utilization % on Supervisor module

It's enabled by default and cannot be disabled. You would see it light up only if your backplane utilization is 20% and higher

109
Views
0
Helpful
1
Replies