Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 6509E with Sup720 Loadsharing

Cisco 6509-E with two SUP720 in my environment I would like to achieve

Active / Active with load sharing between the two SUP720, can this be implemented, please advice on configuration.

2 REPLIES

Re: Cisco 6509E with Sup720 Loadsharing

Hi

AFAIK, When you are using 2 MSFCs only one of them would be active and the other would compulsorily in standby mode. So I dont think you would be able to configure active/active configuration.

Refer the following link for detailed instructions on configuring Redundancy using Dual MSFCs:

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a008019f02f.html

Hope this helps.

Regards,

AbhisheK

Please rate all posts!!!

New Member

Re: Cisco 6509E with Sup720 Loadsharing

Could you just disable redunancy and therefore place them in active/active? You would then have to work your routing metric to your upstream device to achieve your load balancing strategy.

157
Views
0
Helpful
2
Replies
CreatePlease to create content