Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 678 NAT Configuration

I am having a hard time configuring my 678 router.

My internal network is 10.1.1.# with a mask of 255.0.0.0

My public ip is 207.###.###.###.

I want to configure the following:

NAT at 10.1.1.91

PCAnywhere pointing to a PC at 10.1.1.8

show int gives me:

eth0 10.1.1.92 255.0.0.0

vip0 207.###.###.### 255.255.255.248

vip1 0.0.0.0 255.255.255.0

vip2 0.0.0.0 255.225.255.0

wan0 Physical Port: Trained

wan0-0 0.0.0.0 255.225.255.0

wan0-1 0.0.0.0 255.225.255.0

VIP1 has been both inside and outside.

VIP1 has also been at 10.1.1.91

=====================================

show nat is all 0s except for

wan0-0 outside 207.###.###.###

vip0 outside 207.###.###.###

I know how to issue the commands.

I just cannot figure out how everything should look.

Thanks in advance.

Glenn Abelson

glenna@abelson.com

1 REPLY

Re: Cisco 678 NAT Configuration

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

90
Views
0
Helpful
1
Replies