Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 7200 with (2) t1's going to (1) E1

how can i bond 2 t1s using either multilink or cef so that i can see the us side as 3 megs. What i want is to get traffic over the 2 t1 to the 1 e1 and then from the 1 e1 to the 2 t1s

1 REPLY
Cisco Employee

Re: Cisco 7200 with (2) t1's going to (1) E1

You can use ppp encapsulation to bundle two T1's togather to get aggregated bandwidth. Here is the link which has sample config for that

http://www.cisco.com/warp/public/793/access_dial/mpp_serial.html

Also following link

http://www.cisco.com/warp/public/793/access_dial/ppp_11044.html

which has example with E1 but its the same for T1's too.

104
Views
0
Helpful
1
Replies
CreatePlease login to create content