Does anyone know, how much memory can cisco7500 hold?
We have cisco 7507 with VIP2 R5K, and it has 128mb dram and 4smb sdram.
We would like to upgrade memory on cisco7500 to maxium, but it seems like 128mb is the maxium amount of memory which cisco 7500 can support. We are trying to find out if we can put more memory on the router. If not, is there any module that only hold memory to support routing and switching on router??
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...