Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 7513 with writing problems

I have a 7513 which can not save the actual configuration whe i try put the comand write, I receive the next error:

Building configuration...

% Cannot communicate boot variable to slave

% Cannot communicate boot variable to slave

% Cannot communicate boot variable to slave[OK]

Copying config from Master to Slave...

% Error: 37380 bytes needed in slavenvram:

only -1 bytes available.

The last modification was a change in some access-lists and a clear ip bgp.

Thanks

1 REPLY
Cisco Employee

Re: Cisco 7513 with writing problems

Try the following

NWTRCHN-C75-1(config)#slave auto-sync config ---------> Turns on the

automatic synchronization mode.

NWTRCHN-C75-1(config)#end

NWTRCHN-C75-1#copy system: running-config nvram:startup-config

-------------> Saves this information to your startup configuration and

copies the configuration to the standby's startup configuration.

For more information of this, refer to below url:

http://www.cisco.com/univercd/cc/td/doc/product/core/cis7505/rte_swit/2026rsp2.htm#xtocid43

Also what IOS version are you running. Take a look at the following field notice/bug

http://www.cisco.com/warp/public/770/43.shtml

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCdr98566

139
Views
0
Helpful
1
Replies