cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
727
Views
0
Helpful
1
Replies

Cisco 800 Series routers

rdalgren
Level 1
Level 1

Sorry to post such a newbie question, but, I am not a network admin, but, I have been forced into the role for a project I am working on.

Here is my problem:

I have to extend our network from our warehouse to another off-site warehouse via an ISDN line (IP traffice only). I purchased two Cisco 800 Series routers and have used the "Fast Start" software to configure both of them. I know I have the ISDN information (spids, etc.) correct and the line seems to be connecting (I watched via Monitor), but, I can't seem to get the IP traffic to route correctly.

Here is the basic IP info....

Current warehouse:

10.17.x.x

255.255.0.0

New warhouse:

10.20.x.x

255.255.0.0

Can anyone give me any suggestions on this problem?? I know this isn't much information, but, I am not sure what to post...

1 Reply 1

ali-franks
Level 1
Level 1

Hi Richard,

Can you post the complete config minus passwords and phone numbers?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco