Try using Cisco fast step, if you dont want to use CLI. Its the easiest way to configure 800 series routers, if you dont want to get involved in the technical hassle of configuring the router through CLI.
This link tells you how to use dialer profiles to dial from a single site to multiple remote sites. So on the hub, two dialer profiles have been used. You just need to configure one dialer profile in your case, since you have only one remote.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...