02-13-2003 12:16 PM - edited 03-02-2019 05:05 AM
Dear Forum!
I have configured in my Cisco LAN with an 803 Router and an 1950 Switch an DHCP Server on the Router. I receive an IP from the configured pool, but as when I configure a host pool with the hardware address of my clients network card, I still just get one IP out of my dynamic pool. I am using (at least I think) the right media type (01 for ethernet) and I also compared the hardware address on my cisco dhcp server: when I get one of the pool addresses, it shows my MAC address.
This is my host config:
ip dhcp pool chris
host 192.168.13.13 255.255.255.0
hardware-address 0100.00e2.5df3.49
default-router 192.168.13.1
dns-server 195.3.96.67 195.3.96.68
client-name hoelzl
lease 0 7
My ios version: IOS
C800 Software (C800-NSY6-MW), Version 12.0(7)T, RELEASE SOFTWARE (fc2)
Anybody an idea what the failure is?
best regards
chris
Solved! Go to Solution.
04-16-2003 07:21 AM
hi,
it finally worked on my 2500:
i replaced:
"hardware-address 0100.00e2.5df3.49" wih
"client-identifier 0100.00e2.5df3.49"
sometime cisco cammand are stranges ?
C U
02-18-2003 04:47 PM
I am experiencing the same/similar issue. Let me know if you have any success.
04-16-2003 07:04 AM
Exactly the same on a 2500 ios 12.1(9)
04-16-2003 07:21 AM
hi,
it finally worked on my 2500:
i replaced:
"hardware-address 0100.00e2.5df3.49" wih
"client-identifier 0100.00e2.5df3.49"
sometime cisco cammand are stranges ?
C U
04-21-2003 01:39 AM
hi,
the same solution worked on the 803 Router. Thx a lot for your help.
I don't understand the reason, too, but I'm already at a step with IT where I don't want to know all answeres to the whys any more.
ciao.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide