Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cisco 805 buffer

I have configured NAT on a cisco 805 to share internet access for 10 computers. But the access often goes down i don't know why.

But what is sure is that when i reboot the router immediatly the access runs good. So i want to know which parameter i have to configure to avoid this disfunction....

see the config file attachs to this mail

regards

1 REPLY
Silver

Re: Cisco 805 buffer

I observed some missed items in your configuration attachment. There is no "ip nat inside" command for Ethernet0 interface. I think that's creating problem for you.

83
Views
0
Helpful
1
Replies
CreatePlease to create content