Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

dgj
New Member

Cisco 828 Ethernet Duplex

Using IOS c828-oy6-mz.123-5b.bin can't change the duplex on the Interface Ethernet0 on a Cisco 828 router.

Which IOS is recommended as I'm getting quite a few errors on this port (due to mismatch)

Thanks

DG

3 REPLIES

Re: Cisco 828 Ethernet Duplex

I'm not extremely familiar with the 828, but according to the data sheet at

http://www.cisco.com/en/US/customer/products/hw/routers/ps380/products_data_sheet09186a0080088733.html

the router includes a "10 MB Ethernet—Four Port Hub". This implies to me that the ports are not capable of full-duplex. If they were, I would think the marketing folks would have said "four port switch" instead.

Unless someone else has more experience with this device, you may want to call your Cisco rep or open a TAC case online at

http://tools.cisco.com/ServiceRequestTool/create/launch.do

Regards,

Swack

dgj
New Member

Re: Cisco 828 Ethernet Duplex

We also have an 828 running c828-oy6-mz.122-8.YM.bin which allows duplex settings in the config of the interface.

It doesn't show it when I do a "show conf" but appears as "Full-duplex, 10Mb/s" in a "show int eth0"

I don't really want to downgrade the IOS from the 12.3 model - just wandering if there's an "upgrade" so I can use all the facilities.

Thanks

New Member

Re: Cisco 828 Ethernet Duplex

It's possible to do the same on a Cisco 1605R?, ie, Exist a IOS that support Full Duplex on 1600 Router?.

thanks

565
Views
0
Helpful
3
Replies
CreatePlease login to create content