Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

Cisco 837 VPI limit?

I have searched high and low for a solution to this problem but it seems nobody else ran into it.

I recently purchased on the cheap a new CISCO837 router and I am trying to make it work with my provider.

The problem is my provider PVC (VPI/VCI) parameters are 100/100 and this router will NOT accept anything higher than 31

for the first part. It will accept 31/100 but not 32/100. I even upgraded the software but no luck!

When I do #sh dsl int atm0 all dsl parameters (line speed, nise margin, attenuation) seem to be normal except there is no traffic

I have a couple of CISCO2610XM routers with ancient ADSL WICs in them and they work fine with above parameters.

Does anyone have a solution to this?

Is the limit hardwired in the ios or the firmware?

Should I start using this router as a doorstop?

236
Views
0
Helpful
0
Replies
CreatePlease login to create content