cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
231
Views
0
Helpful
1
Replies

Cisco bridging compatibility withother vendors' equipment

wiztech
Level 1
Level 1

The problem we are having is the following:

We have a Cisco 36xx and an Ericsson (ex-ACC) router that are connected with Frame Relay routing IP,but we cannot configure for transparent bridging (i.e. to pass LAT through the FR connection).The Ericsson router uses 802.1d for bridging.Cisco uses the same protocol for bridging.

How can we configure the Cisco router in order to be able to have transparent bridging between the Cisco and the Ericsson router until the Ericsson hardware is replaced by Cisco hardware?

1 Reply 1

scarothe
Level 1
Level 1

Greetings:

YOu didnot put the configurations try it first with IP routing and IETF. If that works, it will verify the F-Relay connection is good. Then, set up a F-Relay map bridge with IETF and an bridge group and see what happens.

Steve

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: