I have been given 2 x 2970TS Switches and wondered whether I could obtain a bit of advice. The one switch has been installed at my home-office and works fine. Info given seems to pint to the fact that the switch is manageable, so we have decided to install a Wireless Security area covering approximately 50 homes.
My query though is whether I would need to configure the switch at all, using an external Wireless Access point connected to the 2970?
I noted in some of Cisco's documentation that I could access the switch by using a RJ-45 cable from a PC directly connected to any of the switch's RJ-45 ports. By entering "10.0.0.1" in my webbrowser, I should be able to access the Switch. Nothing happens though - is there a way to "reset" the switch in case the previous owners have changed the IP address? Is there another way to access it??
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.