Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Catalyst 4006 Switch

Dear all,

Could anyone of you help me on the following issue.

Cisco 4006 switch with supervisor engine II ws-x4013 status LED glows both green and after a minute amber.We replaced with sup II but no result. The chassis is loaded with 2 x ws-x4148-RJ line cards

and 3x580 watts power supplies.

Apart from sup II what went wrong and where can we look to solve the problem.

Thanks and looking for your answer

swamy

2 REPLIES
Purple

Re: Cisco Catalyst 4006 Switch

have you looked in the logs . Do a show test command and see if it tells you anything and then do a show mod and see if anything shows faulty.

New Member

Re: Cisco Catalyst 4006 Switch

The switch was being monitored remotely. We finally reple the chassis 4006.

Thanks

swamy

247
Views
3
Helpful
2
Replies