Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Catalyst 4006

Hi,

I have a Cisco Catalyst 4006 with Supervisor 3 Engine.

Below is the show version command:

Cisco Internetwork Operating System Software

IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.1(20)EW1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Copyright (c) 1986-2003 by cisco Systems, Inc.

Compiled Mon 01-Dec-03 19:31 by eaarmas

Image text-base: 0x00000000, data-base: 0x00F57254

ROM: 12.1(12r)EW

Dagobah Revision 55, Swamp Revision 16

Switch uptime is 1 week, 4 days, 14 hours, 55 minutes

System returned to ROM by reload

System image file is "bootflash:cat4000-i5s-mz.121-20.EW1.bin"

cisco WS-C4006 (MPC8245) processor (revision 7) with 262144K bytes of memory.

Processor board ID FOX07480045

Last reset from Reload

1 Ethernet/IEEE 802.3 interface(s)

1 FastEthernet/IEEE 802.3 interface(s)

146 Gigabit Ethernet/IEEE 802.3 interface(s)

467K bytes of non-volatile configuration memory.

Configuration register is 0x2102

When I access to Web Interface and try to connect to the CiscoView Device Manager 5.3.4 Cat4000IOS 6.0 I see an x mark on the new page and nothing else.

My question is how to be able to monitor this switch and if there are any upgrades I should do to do this.

Thanks in advance,

Charris

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Cisco Catalyst 4006

You will need embedded Cisco view image

http://www.cisco.com/cgi-bin/tablebuild.pl/cview-cat4000

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_20/config/intro.htm#1046822

Or you could use Cisco Network Assistant(CNA) for web interface. But you will need a 12.2 IOS for CNA support. You can upgrade to 12.2(25)EWA5

PS: Remember to rate useful posts.

1 REPLY
Cisco Employee

Re: Cisco Catalyst 4006

You will need embedded Cisco view image

http://www.cisco.com/cgi-bin/tablebuild.pl/cview-cat4000

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_20/config/intro.htm#1046822

Or you could use Cisco Network Assistant(CNA) for web interface. But you will need a 12.2 IOS for CNA support. You can upgrade to 12.2(25)EWA5

PS: Remember to rate useful posts.

309
Views
0
Helpful
1
Replies