Absolutely. You can assign pre-determined privilege levels, which is probably the easiest solution (there are 16 predefined priv levels, with 15=full access). See link below for details. If you really want to get granular, there is a way to create custom privilege levels and specify each and every command a given user can and cannot execute, but that's probably outside the scope of this discussion. Let me know if this does not answer your question.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...