04-18-2003 04:34 PM - edited 03-02-2019 06:45 AM
During an upgrade of a COS the standby sup engine is not coming up.
The active Sup comes up as expected. How can I get the the secondary to sync? During boot on the active it says "Module 2 is found but not in standby"
When I go to the console on the secondary it is romon. We had to delete the
old file from flash so when you do a dir bootflash: it shows the old file. Any help would be appreciated.
04-20-2003 08:22 AM
If the Sup lets you to boot from, boot it from the old image. What kind of switch is it? Does it have a PCMCIA slot? If it does, and you have a flash card, try booting from flash card using the same version as in active Sup
04-20-2003 01:47 PM
Thank you for your reply. Off the top off your head what do you know the syntax to copy tftp -> slot0? Once I get the new version on the switch will the switch automatically sync?
04-20-2003 04:17 PM
Since you already have one Supervisor up, you must be having a valid file in the device bootflash. Port it to the flash card using "copy bootflash:
Example
Switch> (enable) copy bootflash:cat6000-sup2.6-3-10.bin slot0:
18889712 bytes available on device slot0, proceed (y/n) [n]? y
ccc
File has been copied successfully.
Using this flash card, boot the other supervisor which is in rommon
rommon1>boot slot0:cat6000-sup2.6-3-10.bin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide