Hi, I'd like to know which Cisco router families featured with Ethernet modules are able to run full duplex mode. For example, I do have a 4700 running 12.1(13) with an ethernet module that doesn't accept full duplex, by the other hand a 3640 running 12.3(3) is able to do that with an ethernet as well. Is there any hardware (ethernet card) issue here, or it's just a matter on chassis and IOS versions?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.