I have installed CNA 5.5 and it works fine with most of the devices, including catalyst 4500 series with different supervisors (WS-X4013+, WS-X4013+TS, WS-X45 SUP6-E).
It can also detect supervisor WS-X4013+10GE, but CNA failed to show this device in Front Panel View. Is there anything I have to do to make the devices with Supervisor WS-X4013+10GE to be shown in Front Panel View?
WS-X4013+10GE are in either 4503 or 4506 chassis, running IOS version 12.2(31)SGA or 12.2(40)SG.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.