Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco Network Registrar & Active Directory

I am planning an upgrade of our NT 4.0 Domain to a Windows 2003 Active Directory Domain.

We currently have Cisco Network Registrar 5.5 as our DNS servers. Our zone is xyz.com.

I want our upgraded Active Directory Domain to have the same name; xyz.com

I am going to do the following steps in CNR:

1. Enable dynamic DNS updates for the forward and reverse zones

2. I am going to limit the ability to dynamically update the zone by only the allowing the ip addresses of our domain controllers.

Is this all I have to do or are there more steps?

Am I missing anything?

Thanks in advance

1 REPLY
Silver

Re: Cisco Network Registrar & Active Directory

Right place to verify your procedure is in the document below:

Upgrading From an Earlier Software Release

http://www/en/US/products/sw/netmgtsw/ps1982/prod_release_note09186a00800fec9a.html#17724

119
Views
0
Helpful
1
Replies
CreatePlease to create content