02-14-2006 03:44 AM - edited 03-03-2019 01:50 AM
We have a pair of Cisco PIX 515 ( which has since been faced out), now one of them is faulty and needs to be replaced.
Can we replace just one of them with a Cisco PIX 515E or do we need to replace both of them with Cisco PIX 515E?
Thanks
02-14-2006 03:59 AM
Hi Friend,
AFAIK in order for Cisco PIX Failover functionality to work, you need to ensure that both units are the same model and have the same software version, encryption licenses, Flash memory, and the same RAM. Failover between the Cisco PIX 515E and 515 is not supported.
You need replace both of then with Cisco PIX 515E.
http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_qanda_item09186a0080091b17.shtml
This link will tell you the difference between 515 and 515E and also have some FAQ about the 2 and also have an answer if you can use the 2 different model for to work together in a redundant hot standby pair.
HTH, if yes please rate the post.
Ankur
02-14-2006 04:03 AM
Hi
PIX 515 has reached EOS status so i dont think you will be able to get that from Cisco instead you can think off going on for 515E which is the recommended replacement for the same.
But are you currently running any kinda loadbalancing/failover between them ?
if thats the case then you need to think off going on for similar models to achieve that.becoz thats the one of the main requirements before configuring failover or loadbalancing between them.
"Hardware Requirements for failover"
The two units in a failover configuration must have the same hardware configuration. They must be the same model, have the same number and types of interfaces, the same amount of Flash memory, and the same amount of RAM.
regds
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: