I am not sure if my problem is related to here but did not find a better section.
I have a problem with Cisco RSP8 when I switch on
the RSP lights both master and slave and did not initialize, I tested with 2 7507 chasises with no success, there is nothing on the console, do you have any advice what could be the problem and what can I do ?
I ment that the both leds on the RSP - master led and slave led are on, not that I have master and slave rsp. Sorry for not explaining right. Normally when the RSP boots it lights in the beginning the both and then the one led goes off. But in my case the both are on without one of them to go off. Because the rsp just came I am wondering if it could be incompatibility with the chasis ? I mean incompatibility with the revision or something. Both the chasises work flawlessly with RSP4s .
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.