I have a 'newbie' type question about the physical installation of a Cisco 4006 switch. I used the console connection to make the initial configuration changes. There are 2 GBIC ports, 1 console and 1 management port in the supervisor module. We are not using fiber. I THINK the RJ-45 s/b connected via the me1 port (which is UP) to the hub that is connected to the outside interface of the PIX. I got a green light on both ends but no connectivity. I can't ping the PIX or outside router. The sc0 port is administratively down.
Anyone have a moment to help me out? Thanks in advance.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.