Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco View 5.4 don´t show any traffic on an Catalyst 4006 Interface

Hi,

we have a problem with a Catalyst 4006 and Cisco View 5.4 in CiscoWorks 2000 Lan Network Management Solution. When we connect the 4006 and then wants to monitor an Interface we dont see any traffic. The graph remains always on zero percent in all Traffic Windows. Any Idea?

Catalyst 4006 IOS SW 12.1(8a)EW1

Regards

Uwe

2 REPLIES
Blue

Re: Cisco View 5.4 don´t show any traffic on an Catalyst 4006 I

Have you installed the latest device package?. Is there enough traffic on that interface that scales upto the graph axis?. Have you run it long enough to get some data?

New Member

Re: Cisco View 5.4 don´t show any traffic on an Catalyst 4006 I

Yes i have installed the latest device package. We monitored a port with a file server connected, there is a load of traffice the CLI from this interface show 39/255 and 46/255 RX/TX load. I run the monitor over onr hour with an interval of 5 seconds, nothing happend to the graph.

100
Views
0
Helpful
2
Replies