Cisco WLC 2125 and AIR-LAP1252AG-A-K9 access points
We are running into a little issue here and looking for some help. We have the Controller configured and it appears to be working properly the issue we are running into is that we can only get the above mentioned access points to only join the controller if they are plugged directly into the controller. I would assume that we should be able to plug these access points into any of our switches and they should be able to join the controller correct? Obviously there has to be a configuration issue somewhere and am hoping someone can point us in the right direction.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...