I've installed cisco works with whatsup gold on a windows 2000 server, applied sp2. And now when i connect to the server it's very slow, and i can only connect if i use a port number aftre the server name.
For the moment i'm also running it on a nt4 server, without any problems.
What version of CWW are you using?. For CWW 6.1, you don't need to type a port# to access the Desktop if you're launching it directly from the server it self. Other factors could be version of the web browser, client hardware/software requirements, Anti-Virus software running on the client/server can also slow down the performance etc.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...