I have a site that has 3 AS4-FXS gateways and 2 DT24+ Gateways. When I discovered the CM, it brought back the info all all the gateways but it seems to think that the AS4 Gateways are Digital. What are the capabilities of ITEM supporting AS4 and DT24 Gateways.
2. I have some VG200 in my ITEM system but when I perform a CiscoView on them, it does not always show the VWIC-1MFT-T1 card inthe NM-HDV module. It just shows a black box where the card should be. Is this a MIB issue?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...