Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cisco2610xm can't detect internal modem?

2610xm+16am

ios:c2600-i-mz.122-8.T4.bin

show modem version

Slot 1:MCOM Analog Integrated Modem Firmware Version 1.2.8

Source: IOS

Boot firmware: 1.1.5

MIMIC firmware: 1.3.3

Modem firmware: 2.3.17

DSP firmware: 0.0.2

Router#sh line 33

Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int

I 33 TTY - inout - - - 0 0 0/0 -

Line 33, Location: "", Type: ""

Length: 24 lines, Width: 80 columns

Status: No Exit Banner, CTS Raised

Capabilities: Modem Callout, Modem RI is CD,

Line usable as async interface, Integrated Modem

Modem state: Idle

modem(slot/port):1/0, csm_state:IDLE_STATE,

bchan_num:-1 csm_status(0): CSM_STATUS_UNLOCKED

Modem hardware state: CTS noDSR DTR RTS

TCP/IP header compression enabled

Special Chars: Escape Hold Stop Start Disconnect Activation

^^x none - - none

Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch

00:10:00 never none not set

Idle Session Disconnect Warning

never

Login-sequence User Response

00:00:30

Autoselect Initial Wait

not set

Modem type is unknown.

Session limit is not set.

Time since activation: never

Editing is enabled.

History is enabled, history size is 10.

DNS resolution in show commands is enabled

Full user help is disabled

Allowed input transports are pad v120 telnet rlogin udptn.

Allowed output transports are none.

Preferred transport is telnet.

No output characters are padded

No special data dispatching characters

1 REPLY
Silver

Re: cisco2610xm can't detect internal modem?

The detection of internal modem looks just fine, show modem version says it's a MicroCOM Analog Integrated Modem.

Maybe you are refering to "Modem type is unknown" under "show line x"....this typically is used for external modems attached to the line where IOS discovers what kind of modem is connected to the router and to configure that modem automatically.

If we add "modem autoconfigure discovery" under the line then the NM-AMs will be displayed as "Modem type is microcom_mimic"

Thanks, Mak.

93
Views
0
Helpful
1
Replies