Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

cisco2611 different network routing

I have 2 ethernet ports on the router and no L3 switch but normal L2 switch.Planning to segmentize 2 networks with 2 network communicating each other without involving vlan.Can it be done?

3 REPLIES
Bronze

Re: cisco2611 different network routing

If you only have one switch, then the only way to segment it is by using VLANs. With multiple switches, you can connect the router ethernet ports to each and route between them.

New Member

Re: cisco2611 different network routing

I don't want to get vlan involved.Is it posibble?

Since I have 2 ports on my router?All my ws gateway will be on router ethernet port IP.

New Member

Re: cisco2611 different network routing

d-

Yes, this is possible. All you have to do is configure each of your subnets on the different interfaces on the router. Having different subnets is not VLAN dependent. However, what is it that you're trying to achieve. Perhaps there is another way. By segmenting your IPs, you're not doing anything to limit wour broadcast domain which is usually why you would segment in such a way.

-Bo

89
Views
0
Helpful
3
Replies
CreatePlease to create content