Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CISCO2621XM I/O Memory

Could you please help ... DFM notice to I/O insufficient memory. 1c hannerized T1PRI + 2 Fa Ether are used. Tried to use Memory Culculater on TAC. However, it does not make sence.

What is the appropliate memory allocation rate on this router ?

****************************

cisco 2621 (MPC860) processor (revision 0x102) with 28672K/4096K bytes of memory

Primary Rate ISDN software, Version 1.1.

2 FastEthernet/IEEE 802.3 interface(s)

24 Serial network interface(s)

1 Channelized T1/PRI port(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

**********************

Head Total(b) Used(b) Free(b) Lowest(b) Largest(b)

Processor 80B58B54 17462444 3420020 14042424 13721964 13700324

I/O 1C00000 4194304 3837112 357192 357192 350268

2 REPLIES
Blue

Re: CISCO2621XM I/O Memory

Is this DFM 1.2 with IDU 1.2.4 installed?

Community Member

Re: CISCO2621XM I/O Memory

Yes, DFM1.2 is installed. what's IDU ?

Thank you,

104
Views
0
Helpful
2
Replies
CreatePlease to create content