Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Cisco3550 Printer connection

When connecting a printer to a jack that's patched to port fa0/10, I get nothing no link light. But When I connect a pc I get connectivity. Why no connection for the printer? I confirmed printer is good w/another port on the same switch and it works. Any suggestions on cause and resolution. Your feed back will be greatly appreciated. Thank you

  • Other Network Infrastructure Subjects
1 REPLY

Re: Cisco3550 Printer connection

Check the speed/duplex settings for the port. It's possible that these are hard coded on fa0/10 to a value that matches the PC, but not the printer. Set them to auto and see if you get a link.

Brandon

218
Views
0
Helpful
1
Replies