I have a Cisco677 router connected between the internet and my computer. I have "my own" IP and has configured my computer to WOL. But how do I do it through the Cisco677 ????
I wan't to be able to start my computer from work, but I can't get the computer to "wake". I gues that I need to open some port and mayby configure a MAC adress, but I'm not a genius to this, and need som userfrendly help.
I think Wake on LAN is just that and cant work over a WAN connection. Youll probably have to look into an alternative like a dial-up power switch or timed wake device. If you had a router that performed IPSEC (like an 800 series) you could VPN youre your home network and then wake on LAN MIGHT work (I wouldnt see why not) but that would require a router upgrade.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...