Can someone confirm to me that the only way to get configs downloaded from PIX firewalls is via telnet? If trying via SNMP when SNMP connectivity has already been proven you get a " cannot connect to host" error.
Re: CiscoWorks LMS/Config Manager and PIX firewalls
I am trying to get the pix configs managed by Config Manager so that we always have up to date copies. Although I have configured snmp and tacacs/enable passwords, the error I am getting back from RME is "cannot connect to host". Any ideas?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...