i rebooted my widows 2000 server where my ciscoworks is running, but now when i checked the display view on the network topology it doesn't discover newly installed devices anymore and also all of the existing links are red broken lines? What should i need to check? thank you for any reply i can get.
you probably have already done this, but you might want to check if all your services on your W2K are running, especially the ANI database engine. Here are some services that are typically installed and should be running:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...