Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CiscoWorks2000 Missing Subnets

When I go to user tracking all the mac address' are there but certian subnets are missing information like ip address host name ect... ,but some subnets are coming up with all the info. I am new to this product, can some one suggest where to start to troubleshoot?

2 REPLIES

Re: CiscoWorks2000 Missing Subnets

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Community Member

Re: CiscoWorks2000 Missing Subnets

I have a similar problem. I had LMS1.0 and opened a case on it this spring; I was told to install LMS1.1 when it came out and to also install a patch (UT 3.1 patch 2). Unfortunately the problem still exists. It appears that IP addresses on VLAN 1 get resolved but not addresses on other VLANs.

139
Views
0
Helpful
2
Replies
CreatePlease to create content