Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

clear a port channle in Catalyst 4006-S2

A Catalyst 4006-S2 with a WS-X4013, 2 WS-X4148-RJ s and a WS-X4306, soft ware is cat4000.6-2-2.bin. The problem is : I miss configured port 4/5-6 to be a channel with command "set port channle 4/5-6 mode on",and in roder to clear this channel, I use the command "set port channle 4/5-6 model off". then the show config command shows that "set port channle 4/5-6 mode off". I can not find the command "clear channle 4/5-6".

How can I clear this channel completely without using the command "clear config"?

Thank you.

1 REPLY
Cisco Employee

Re: clear a port channle in Catalyst 4006-S2

The default mode is auto. Try "set port channel 4/5-6 mode auto" and then do a "show config 4"

170
Views
0
Helpful
1
Replies
CreatePlease to create content