You can clear the command history buffer with an exec command. The history buffer size defaults to 10 but you can control the size. If you want to change the size permanently you use a command in line configuration mode: history size and if you want to change it only for your session you use this command in exec mode: term history size .
So if you want to clear or reset the history buffer I would do this:
term history size 0 (which empties the buffer)
term history size 10 (or whatever value it had been set to).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...