We have encountered routing problem on one of the IP block from our distribution router where the IP from that block is unreacheable to other networks. Some router shown that the routing entry known from the router it was connected while other router is not. With this, we've tried to command the "clear ip ospf redistribution" where as the connection went back to normal and the routing table have seen the proper routing.
Could anyone help us to avoid the repeat of this problem?
The clear ip ospf redistribution command flushes all the type 5 and type 7 link-state advertisements (LSAs) and scans the routing table for the redistributed routes. This causes a partial shortest path first algorithm (SPF) in all the routers on the network that receive the flushed/renewed LSAs. When the expected redistributed route is not in OSPF, this command may help to renew the LSA and get the route into OSPF
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...