Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CLID

HI all

I have 3640 (IP ONLY) with nm-16-am and the telephone line connceted to the 3640 have CID.

My client A have phone number 123456 and have to dial to number 111111, B have phone number 123123 and have to dial 222222, and C have phone number 321321 and have to dial 333333.

If client A dial to 111111 from different number from 123456 they can't connect.

With my device can't 1 do that, if not, please give me your advice, what must i do and what equipment and softwaere i must have.

Please help me,

5 REPLIES

Re: CLID

have u configured CLID on the router , to allow only calls from that particular number.

New Member

Re: CLID

Thank you for your attention,

Ya, i have configured my 3640, but it doesn't work.

Could you give me a example of the configuration to make it happen.

Thank You so much.

Thomas

Re: CLID

in your 3640, add all the phone numbers from which A wants to dial.

If you are using dialer profiles...under the dialer profile interface defined for A, use following command.

dialer caller 123456

dialer caller 123457

dialer caller 123458

This will cause 3640 to accept calls from A from the above 3 numbers.

If you are using legacy DDR configurations on physical BRI interface.

you should use,

isdn caller 123456

isdn caller 123457

isdn caller 123458

Hope its clear.

New Member

Re: CLID

Thanks a lot for your advice, I'm so sorry 'cause I can't try it yesterday. I try your advice today.

Thanks you again.

Bronze

Re: CLID

The Analog Modems do not provide DNIS or CLID to IOS, so there is no way to enforce either one.

107
Views
0
Helpful
5
Replies
CreatePlease to create content