clockrate

[mhostbaek]

I have set up a test environment, with to routers connected to each other serial interface though a back-to-back cable. I have set the clockrate on the DCE end. I'd like to know, if it is somehow possible to see the assigned clockrate on the DTE end ?

'sh controllers serial ' oly says 'TX and RX clocks detected'

Thanks.

/mich

[lgijssel]

It depends on the hardware / software you use. Try a search for the word clockrate for all forums on this page. You will see that the question has been asked before with various results.

Regards,

Leo