1. I have just put in a 2950-12 switch at a remote location that is connected to my office via a 256K frame relay circuit. The CMS is very slow to open the web console i can telnet into the switch with no problem. How do I increase the speed of the web console?
2. Can I connect remote locations in one cluster? The remote locations are all connected by frame relay circuits back to the main office. Each office has it's own subnet.
The switches in a cluster can be in the same location, or they can be distributed across a contiguous Layer 2 network. All communication with cluster switches is through one IP address. Here's the guide to creating and managing clusters.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...