Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Clustering between 3524PWR and 3548

Can clustering be done on GBIC 0/2 interface on all switches leaving GBIC 0/1 open?

1 REPLY
New Member

Re: Clustering between 3524PWR and 3548

Clustering can be done using any interface providing that the cluster is configured properly. If you are using the stacking GBIC, just place them all in gi0/2 and connect. I have configured clusters that are not even directly connected (each switch has a home run to a 6509) Sometimes proximity does not allow you to use a stacking GBIC.

99
Views
0
Helpful
1
Replies