I am trying to get the 2950 to join an existing cluster. Usually when we add a 3500 it is automatically detected in the cluster builder. I have tried entering the Masters Mac address and configuration the same as our other 3500 switches and this still does not work. I have the switches connected via GBIC and the switch-port mode is Trunk.
I see traffic in both direction on the interface. though no traffic is passing through for me to ping anything.
Was there a specific change in the 2950 that need to be changed to allow it to cluster with older 3548XL switches?
is my understanding correct the 3548XL is the master?
This is not recommended.
"If your switch cluster has Catalyst 2900 XL, Catalyst 2940, Catalyst 2950, Catalyst 2950 LRE, Catalyst 2955, and Catalyst 3500 XL switches, the Catalyst 2950 or Catalyst 2955 switch should be the command switch. "
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...