I am trying to get the 2950 to join an existing cluster. Usually when we add a 3500 it is automatically detected in the cluster builder. I have tried entering the Masters Mac address and configuration the same as our other 3500 switches and this still does not work. I have the switches connected via GBIC and the switch-port mode is Trunk.
I see traffic in both direction on the interface. though no traffic is passing through for me to ping anything.
Was there a specific change in the 2950 that need to be changed to allow it to cluster with older 3548XL switches?
Can it cluster with a 3500XL switch?
This cluster has only 2 switches in it.
The 2950 is brand new out of the box.
David