02-15-2002 07:14 AM - edited 03-01-2019 08:30 PM
Hi!
I'm implementing diffserv in a 7200 cisco router with IOS12.2(2)T. I've configured the classes and policy-maps as described in the paper
"Implementing Diffserv for End-to-End Quality of Service Overview".
This configuration is done with a wrapper in java I've made. Now I want it to do some monitoring. So I have to colect some information. But with the CLI I can't get the information by source address/destination address/dscp.
I really can't discover any command that shows the traffic related with any address. Is what I'm asking impossible or is there any way of getting this
information.
Thanks in advance.
-------------------------------------------------
Emanuel António Raimundo Moreira
Instituto de Telecomunicações - Pólo de Aveiro
Campus Universitário
3810-193 AVEIRO - PORTUGAL
Telef. +351 234 - 377900
Fax. +351 234 - 377901
e-mail: emoreira@av.it.pt
-------------------------------------------------
02-22-2002 05:14 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
04-03-2002 05:38 AM
Hi,
I´m really happy to find sb also working on DiffServ-Implementation.
What I did so far on monitoring the queus:
I used to qdm.tar (a Java apllication running on the Router, access via http, available on CCO),
I also decreased the average time-interval from 300 sec to 60 sec and graphed with
the Java-Application validated the marking with the DSCP as well as drops,peaks or
other queue overflows.
At least this shows me that the queuning is working as I exspected. However, at this time I have
no idea how to check the DSCP-based RED with its parameters for congestion avoidance.
best regards, Alfred
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide